Version mups18-3 (firmware version v1.18.0.mups3) of my custom MeshCore firmware is out. It is mainly a bug-fix release, so if you run mups18-2, please update.

What’s new

  • CLI fix: mups18-2 cut off blanks at the end of every command on repeaters, room servers and sensors. Some official commands need that trailing blank, so they failed. “Remove All Neighbours” in the app was rejected with “Firmware Update Required”, and set owner.info with an empty value no longer cleared the owner info. This change has been removed, and the command line behaves exactly like the official firmware again.
  • Fewer redundant transmissions on trace paths: a repeater in the middle of a path trace no longer re-sends each trace after the next hop has already forwarded it. The last hop before the trace destination now sends once through the normal channel check. Normal messages are not affected. Many thanks to Sebastian van de Meer, who found and fixed both issues.
  • Updated base: IoTThinks PowerSaving-v18 as of 2026-11-14. Among the changes: GPS on companions now follows the powersaving setting, there are new companion commands gps, gps on, gps off and gps sync, the GPS on the GAT562 30S is fixed, and the INA228 current sensor is supported.
  • All 26 builds in one release: repeaters, room server and companions for Heltec V3, V4, V4.3 and T096, T114, RAK4631, RAK WisMesh Tag, GAT562 30S, SenseCAP Solar, Xiao S3 WIO, Xiao nRF52, T1000-E, Wio Tracker L1, ThinkNode M6 and LilyGo T-Echo.

Defaults are unchanged compared to mups18-2. The packet filter is still off by default, and when you switch it on it starts in dry-run mode.

As always: use at your own risk, and back up your device’s private key before flashing.

Download and release notes: https://github.com/m0urs/MeshCore/releases/tag/mups18-3
Documentation: https://github.com/m0urs/MeshCore/blob/mups18-release/MUPS18.md

MeshCore V1.18.0.mups3 is out: Bug-fix Release of my Custom MeshCore Firmware
Tagged on:     

Leave a Reply

Your email address will not be published. Required fields are marked *